V2300 Turbo Pump
Technical Specifications
| Vacuum Performances | |
| Pumping speed for N2 (*) | 2050 l/s |
| Pumping speed for He (*) | 1800 L/s |
| Pumping speed for H2 (*) | 1500 L/s |
| Compression ratio for N2 | >8 x 108 |
| Compression ratio for He | 8 x 105 |
| Compression ratio for H2 | 4 x 104 |
| Base pressure* (with recommended forepump) | 10-10 mbar (7.5 x 10-11 Torr) (**) |
| Inlet Flange | ISO 250F, CFF 12” O.D. |
| Foreline flange | KF 40 NW |
| Other | |
| Nominal rotational speed | 33300 rpm |
| Start-up time without gas load and with the recommended forepump | < 6 minutes |
| Minimum recommended forepump | TriScroll 600 |
| Operational position | Any |
| Operating ambient temperature | +5 °C to +35 °C |
| Bakeout temperature | 120°C (CFF), 80°C (ISO) |
| Max rotor temperature | 120 °C |
| Vibration level (displacement) | < 0.01 μm at inlet flange |
| Lubricant | Permanent lubrication |
| Cooling requirements | Water |
| Coolant water | Recommended flow: 200 l/h
Temperature: +15 °C to +30 °C Pressure: 3 to 5 bar (45 to 75 psi) |
| Noise level | <60 dB(A) at 1 meter |
| Storage temperature | -20°Cto+70°C |
| Environment protection | IP54 |
| Weight kg (lbs) | ISO 250: 54.2 (119.5) CF 12”: 55.3 (121.9) |
| (*): WITHOuT INLET SCREEN
(*): According to standard DIN 28 428, the base pressure is that measured in a leak-free test dome, 48 hours after the completion of test dome bake-out, with a Turbopump fitted with a CFF flange and using the recommended pre-vacuum pump |
|
| Controller Specifications | 100, 120, 220, 240 Vac, 1-phase |
| Input voltage | 50 - 60 Hz |
| Input frequency | 1300 VA |
| Maximum input power | 64 Vac |
| Output voltage | 555 Hz |
| Output frequency | 560 W maximum |
| Output Power starting | 450 W maximum |
| Output Power normal | 12,5 kg (28 lbs) |
| Weight (both models) | II |
| Installation category | 2 |
| Pollution degree | 100, 120, 220, 240 Vac, 1-phase |